Brewology

Well, those lines are important. You can't just make the center of the 'O' hover inside the case.
I'll work on it when I get done with my project.

I am putting plexi under it. so i can cut the O part out and place it on there kinda like this

Seeh how the gears looks with parts added on to it like that is what i will do with the middle part for the O

Oh, okay. Yeah, I was going to do this with my PSP. I was going to cut out the silver ring. The plexiglass I got was just too thick.
Knowing that, I'll try some other ideas out.

How about this? Its just rough though... :

So Far Craits Design is in the lead. Now I am waiting for Timeloop to submit his. I may end up taking all your guys designe and combining them into one. lol But so far Crait I like yours the best. and good job DCM your is nice But I am just not feeling ti =D